In some cases the lower or cutting edge of the wooden curb is strengthened or protected by a sheathing of wrought-iron plates.
The detail sketches explain the form of cutting edge, flange joint, and method of bracing.
It may be tapered both ways or one way to a cutting edge, or one edge may be rounded.
It is better to dip slowly, sometimes holding the point, or cutting edge, in the water while permitting the shank to cool slowly enough to remain soft.
A scoop or ring with either a blunt or a cutting edge, for removing substances from the walls of a cavity, as from the eye, ear, or womb.
The feed screw is not provided with either a squared head or with the usual pin holes, because the feed ratchet is so readily operated that these, with their accompanying wrench or pin, are unnecessary.
The bolt K then has fallen to the amount due to unscrewing the threaded or nut end of L, and also to the amount of the difference of thickness at M and at m of the washer, the plate N being clear of the lathe-shears.
A and A' are the shears connected at intervals by cross girts or webs B to stiffen them.
K represents the key with its trued edge against the fixed jaw, at P is a piece put in to compensate for the taper of the key, and to cause the other edge to bed firmly and fairly against the fixed jaw.
It has a cutting edge e which shaves off the metal as indicated in the end view by the dotted lines.
Tools Ground so that Top Slopes away from Working Part of Cutting Edge] =Example of Boring.
Evidently this method is confined to comparatively small diameters and the squareness of the turned end will be determined by the position of the tool's cutting edge.
The sharp or cutting edge is only on the short side, the other is flat or half-round.
If a cutting edge is to be covered the tinfoil on one side of the blade must overlap the edge which is pasted on the opposite side.
After completing the [Illustration: Details of Handle] handle, the blade is put back into the groove and sharpened to a cutting edge.
The hammer head is caused to strike the metal just over the cutting edge of the chipper.
A celt of shorter proportions, but also provided with a cutting edge at each end, is shown in Fig.
To produce a cutting edge it is necessary that the metal behind that edge should slope or slant away leaving the cutting edge to project.
Now if T T be a 1-pitch template as above mentioned, it is clear that N will correctly shape a cutting edge of a gear cutter for a 1-pitch wheel.
This tool should be made slightly narrower than the width of the worm space, so that it may not cut on both sides at once, as it would have too great a length of cutting edge.
The incisor teeth are long, curved, and strongly enameled on the outside, so as to keep a cutting edge.
The above list will hopefully provide you with a few useful examples demonstrating the appropriate usage of "cutting edge" in a variety of sentences. We hope that you will now be able to make sentences using this group of words.
